Publicité
Les langues disponibles
Les langues disponibles
5.0 FINISHING
POWER SUPPLY SERVICE MUST BE COMPLETED PRIOR TO FINISHING TO AVOID
HEAT VENTS AND AIR OPENINGS CANNOT BE COVERED IN ANY CIRCUMSTANCES.
5.1
GLASS DOOR REMOVAL AND INSTALLATION
FACING AND/OR FINISHING MATERIAL MUST NOT INTERFERE WITH AIR FLOW THROUGH AIR
OPENINGS, LOUVRES OPENINGS, OPERATION OF LOUVRES OR DOORS OR ACCESS FOR
SERVICE. OBSERVE ALL CLEARANCES WHEN APPLYING COMBUSTIBLE MATERIALS.
BEFORE DOOR IS REMOVED TURN THE APPLIANCE OFF AND WAIT UNTIL APPLIANCE IS COOL
TO THE TOUCH. DOORS ARE HEAVY AND FRAGILE SO HANDLE WITH CARE.
A.
Remove the 4 screws off the appliance, as shown.
B.
Remove the glass front and place on a soft non-abrasive
surface.
C.
Reverse these steps to reinstall the glass front.
5.2
LOG, GRATE AND EMBER BED ASSEMBLY REMOVAL
For Model CEFB24H and CEFB27H:
Remove the 4 screws securing the ember bed to the sides (and bottom, if applicable) of the
A.
appliance, as shown.
NOTE: Some models only have two screws.
Lift the log, grate and ember bed up from the appliance and remove.
B.
For Model CEFB29H:
Remove the packaging materials holding the logs, grate and ember bed assembly to the appliance.
A.
Pinch the back of the assembly and lift it up from the appliance.
B.
CEFB27H ILLUSTRATED
SCREW
SCREW
(if applicable)
WARNING
!
RECONSTRUCTION.
WARNING
!
15
SCREW
SCREW
SCREW
(if applicable)
W415-1438 / A / 06.02.17
EN
Publicité
