Publicité
Les langues disponibles
Les langues disponibles
14
4.2
OPERATING BY REMOTE CONTROL
TO AVOID DANGER OF SUFFOCATION KEEP THE PACKAGING BAG AWAY FROM BABIES AND
CHILDREN. DO NOT USE IN CRIBS, BED, CARRIAGES OR PLAY PENS. THIS BAG IS NOT A TOY.
EN
NOTE: When operating the remote control, it must be directed towards the front center of the appliance.
A.
The power button can be used to power up or down the appliance.
Pressing this button
Pressing the power button again will turn off the appliance. The
ember and log will fade out after 4 seconds.
B.
To adjust the flame brightness and ember log light, press the flame
button
levels to cycle through and then an off setting ( LL, F1, F2, F3 and
then F0).F3 is the brightest flame level, LL is the ember log light only.
C.
To begin the thermostat function press the thermostat button
there are 7 temperature settings (61°F, 64°F, 70°F, 75°F, 81°F 85°F
and off). Press the thermostat button to cycle through the settings.
Once you have selected the desired temperature the heater will
automatically function until that temperature is reached. The default
setting will display Fahrenheit. When the room temperature is 2
degrees lower than the temperature setting, the heater will turn on.
D.
To activate the heater and blower, press the heater button
blower will turn on. Press the heater button again to set desired low
or high heat temperature; press the heater button again to turn off the
heater.
E.
The timer controls all operating modes of the appliance. To activate
the timer, press the timer button
time will appear on the LED display. To choose the desired time,
continue to press the timer button, there are 8 settings (30mins,1h,
2h, 3h, 4h, 5h, 6h and off). The fireplace will turn off at the setting time.
F.
To activate the decoration light (CEFB27/29H Only), press the light button
to cycle through and then an off setting (d1, d2, d3 and then d0). d1 white colour, d2 colour cycles from
White / Orange / Blue / Orange-Blue / White-Blue. It will take 8.5 seconds to switch from one colour to
the next when in d2 setting, d3 will lock to a desired colour.
G.
To turn off the appliance, press the power button once on the remote, or press the power button once
on the control panel on the unit.
NOTE: This hand held remote control must remain within 6 meters or 19 feet of the appliance to be
effective.
4.3
REMOTE BATTERY INSTALLATION
1. To replace the existing battery, remote the battery
holder.
2. To remove the battery holder, turn remote onto front
side and press the left side lever towards the center
while pulling the battery holder out using the slot
provided.
3. Replace existing battery, type CR 2025, with a
new battery and reinstall the battery holder into the
remote by sliding it into position, as shown.
4. Battery cover is secure onto the remote control
when a "CLICKING" noise is heard.
W415-1438 / A / 06.02.17
KNOT BEFORE THROWING AWAY.
activates the power to the appliance.
. There is one ember log light and three flame brightness
, the icon will illuminate and the
WARNING
!
,
, the
BATTERY (CR 2025)
BATTERY COVER
* CEFB29H REMOTE ILLUSTRATED
.There are three settings
REMOTE
(REAR SIDE)
Publicité
