TOOLCRAFT 1619736 Mode D'emploi page 27

7. Assembly
Remove the weed sweeper and the accessories from the packaging.
a) Auxiliary handle
• Unscrew the lock nut from the auxiliary handle and push the bolt out of its slot in the auxiliary handle (9).
• Insert the auxiliary handle onto the weed sweeper and secure it in place using the bolt and the lock nut that you
just removed.
The auxiliary handle must click into place in one of the slots on the weed sweeper.
The hexagonal heads on the bolt and lock nut must click into position in the slots on the auxiliary handle/
lock nut.
• The position of the auxiliary handle (9) can be adjusted. To adjust its position, loosen the lock nut, set the desired
position, and then tighten the lock nut again.
b) Guide wheel
• Attach the guide wheel (8) to the corresponding screw on the motor housing.
27