Publicité
Les langues disponibles
Les langues disponibles
English
HOW TO ROURE CABLES
Speed clamps are included with the Plasma Display for tidying
your cables and keeping extra cable length out of the way.
Attach speed clamps at the direction of the running cables.
*
When the Pioneer stand, sold separately, is not used, use the
two holes that are marked with arrows in the diagram (
the holes for attaching speed clamps.
Using Speed Clamps
Wrap the speed clamp around the bundled
cables and press B into hole A.
To remove a speed clamp, use pliers to twist
it 90° and then pull it out. (This may result in
weakening or damaging the clamp.)
Speaker Cable
∞ Rear of Display
Speed Clamp
Mounting Hole
IMPORTANT NOTICE – RECORD THE MODEL NUMBER AND SERIAL NUMBERS OF THIS EQUIPMENT BELOW.
MODEL NO.
SERIAL NO.
KEEP THESE NUMBERS FOR FUTURE USE.
6
SYSTEM
CABLE
WHITE
BLACK
Speed
Speed Clamp
Clamp
Mounting Hole
THE NUMBERS ARE ON THE REAR.
CABINET MAINTENANCE
÷ Use a polishing cloth or dry cloth to wipe off dust and
dirt.
÷ When the cabinet is very dirty, wipe with a soft cloth
moistened with water-diluted cleanser; then wipe again
with a dry cloth. Do not use furniture wax or cleaners.
) as
They may damage the surface of the cabinet.
÷ Never use thinner, benzine, insecticide sprays and other
chemicals on or near the cabinets, since these will corrode
the surfaces.
÷ When a chemical cloth is used, read the cautions for the
chemical cloth carefully.
SPECIFICATIONS
Cabinet: Bass-reflex type
Used speakers (two-way system):
Woofer (for low tones) ................ 4.8 × 13 cm cone type
Tweeter (for high tones) ........... 2.5 cm semidome type
Nominal impedance ..................................................... 8 Ω
Frequency Range ..................................... 70 to 30,000 Hz
Sensitivity (1 w, 1 m) ................................................ 81 dB
Permissible input :
Max. input .............................................................. 13 W
Rated input .............................................................. 4 W
Crossover frequency ................................................ 3 kHz
External Dimensions ...... 76.5 (W) × 632 (H) × 92 (D) mm
Weight ..................................................................... 1.5 kg
Accessory parts (for 2 speakers)
............................................................ Speaker cable × 2
...................................................... Screw (M5 × 10) × 16
............................................................................. Bracket
.............................................................. Padding strip × 2
.............................................. Operating Instructions × 1
NOTE:
Specifications and design subject to possible modification
without notice, due to improvements.
LEFT-TOP × 1
LEFT-BOTTOM × 1
RIGHT-TOP × 1
RIGHT-BOTTOM × 1
D1-4-2-6-2_En
Published by Pioneer Corporation.
Copyright © 2005 Pioneer Corporation.
All rights reserved.
Publicité
