Pioneer Elite PDP-S35 Mode D'emploi page 4

English
3 Screw an enclosed screw into the
speaker mounting hole (lower of the
two) at the top, back of the display.
Do not tighten it all the way yet. Leave it loose, with
about 5 mm left to tighten.
Speaker Mounting Hole
Top of Display
Leave a space of about 5 mm
4 Hang the speaker mounting bracket
on the screw you installed at the top
by passing the wide part over it and
lowering into the slot; screw in the
lower screw temporarily.
After passing the wide part of the hole of the speaker
mounting bracket (top) over the screw, lower the speaker
onto it.
After passing the
wide part of the hole
over the screw,
lower the speaker.
Tighten the bottom
speaker mounting
bracket to the display
temporarily (one place
bottom).
4
Top, Back of
Display
5 mm
5 Adjust the position of the speaker
and then fix the upper and lower
screws firmly.
6 Tighten the two screws, at the top
and bottom for each speaker (total of
four screws), thus fixing the
speakers to the display.