Publicité
Les langues disponibles
Les langues disponibles
ATTENTION:
A 12V DC power adapter (model#: ACCPWR12V1, not included) is only required
if connecting the camera's Ethernet cable to a router or switch that does not support PoE.
2. Connect cameras to a PoE switch or router on your network (not included).
Connect the Ethernet cable to the camera and then connect the other end of the Ethernet
cable to a router or switch on your network. See your NVR manual for details on connecting
the camera to your NVR using a router or switch.
12V DC power
Camera's Ethernet connector
OR
PoE switch
Router's LAN port
11
Using the RJ45 cable gland (optional)
The pre-attached RJ45 cable gland covers both the camera's Ethernet connector and the RJ45 plug
to provide weather-resistance and protection from dust, dirt and other environmental contaminants.
To use the RJ45 cable gland, twist the RJ45 cable gland barrel securely onto the camera's
Ethernet connector.
RJ45 Cable
Camera Ethernet
gland barrel
connector
Cable extension options
You can extend the Ethernet cable run for your camera up to 300ft (91m). To extend the cable run
beyond 300ft (91m), a switch will be required (sold separately). Use an RJ45 coupler or a network
switch (not included) to connect male ends of Ethernet cables together. We recommend using
UL CMR approved cables available at lorex.com.
Cable type
Max. cable run distance
CAT5e (or higher) Ethernet cable
Tip:
The RJ45 cable gland is
weather-resistant. Seal the cap
with silicone and/or electrical tape
for additional sealing if it will be
exposed to precipitation regularly.
Max. number of extensions
300ft (91m)
3
12
Publicité
