Publicité
Les langues disponibles
Les langues disponibles
Mask detection
With face detection enabled, you can set
the alarm type to detect if a person is not
wearing a mask. A person not wearing a
mask or improperly wearing a mask will be
captured in the face preview sidebar and a
notification will be sent through the Lorex
Home App. Enable Mask Detect and
Auto-response to remind a non-mask
wearer to: "Please wear your face mask".
Notes:
• You can enable face detection without using mask detection.
• Face detection is disabled by default. For more information on face detection setup and
configuration, refer to your NVR's manual at lorex.com.
• Face detection and mask detection are compatible with certain Lorex NVRs. For a list of
compatible NVRs, please visit lorex.com/compatibility.
IMPORTANT!
Before Installing
• Test your camera prior to selecting a
permanent mounting location by
temporarily connecting the camera
and cable to your NVR.
• Review "Important installation
guidelines", page 3 before choosing a
permanent mounting location.
• Decide whether to run the cables through
the wall/ceiling (drilling required) or along
the wall/ceiling. If you run the cables
along the wall/ceiling, you must run the
cable through the cable notch located
on the camera base (see Figure 1). This
will keep the camera base flush to the
surface when mounted.
7
Figure 1: Cable notch
8
Publicité
