CONSTRUCTA CN151150 Mode D'emploi page 22

Pausing
Press the "stop" button once, or open the appliance door. After
closing the door, press the "start" button again.
Cancelling
Press the "stop" button twice, or open the door and press the
"stop" button once.
Note: You can also adjust the cooking time first and then the
microwave power setting.
Memory
You can save the settings for a dish in the memory and call it
up again at any time.
The memory is useful for if you frequently prepare a specific
dish.
Saving memory settings
Example: 360 W, 25 minutes
Press the i button.
1.
"M" appears in the display.
Press the required microwave power setting.
2.
"M", the selected power setting and "1:00 min" appear in the
display.
Set the cooking time using the rotary selector.
3.

VWRS VWDUW
   
L J 
Confirm by pressing the i button.
4.
The clock reappears. The setting is saved.
Changing the signal duration
You will hear a signal when the appliance is switched off. You
can change the duration of the acoustic signal.
Press the "start" button for approx. 6 seconds.
Care and cleaning
With careful care and cleaning your microwave oven will retain
its looks and remain good order. We will explain here how you
should care for and clean your appliance correctly.
22

PLQ
NJ
Cooling fan
The appliance is equipped with a cooling fan. The fan may run
on even if the oven has been switched off.
Notes
The cooking compartment remains cold during microwave
■
operation. The cooling fan will still switch on. The fan may run
on even when microwave operation has ended.
Condensation may appear on the door window, interior walls
■
and floor. This is normal and does not adversely affect
microwave operation. Wipe away the condensation after
cooking.
Notes
You cannot save several microwave power settings one after
■
the other.
You cannot save automatic programmes.
■
You can save the memory settings and start the appliance
■
immediately. When finishing, instead of pressing i, press
"start".
Saving a new setting in the memory: press the i button.
■
The old settings appear. Save the new programme as
described in steps 1-4.
Starting the memory
It is very easy to start the saved programme. Place your meal
into the appliance. Close the appliance door.
Press the i button.
1.
The saved settings are displayed.
Press the "start" button.
2.
The cooking time counts down in the display.
The cooking time has elapsed
A signal sounds. Open the appliance door or press "stop". The
clock reappears.
Pausing
Press the "stop" button once, or open the appliance door. After
closing the door, press the "start" button again.
Cancelling
Press the "stop" button twice, or open the door and press the
"stop" button once.
The new signal duration is adopted.
The clock reappears.
The following are possible:
Short signal duration - 3 tones
Long signal duration - 30 tones.
ã=
Risk of short circuit!
Never use high-pressure cleaners or steam cleaners to clean
the oven.