Télécharger Imprimer la page

HQ Power LEDA01RGB Notice D'emploi page 3

Publicité

Les langues disponibles
  • FR

Les langues disponibles

3. General Guidelines
This device is designed for indoor use only.
Lighting effects are not designed for permanent operation: regular operation breaks
will prolong their lives.
Do not shake the device. Avoid brute force when installing or operating the device.
Select a location where the device is protected against extreme heat, dust and
moisture. Respect a minimum distance of 0.5 m between the device's light output and
any illuminated surface.
Familiarise yourself with the functions of the device before actually using it. Do not
allow operation by unqualified people. Any damage that may occur will most
probably be due to unprofessional use of the device.
Use the original packaging if the device is to be transported.
All modifications of the device are forbidden for safety reasons.
• Only use the device for its intended purpose. All other uses may lead to short
circuits, burns, electroshocks, crash, etc. Using the device in an unauthorised way
will void the warranty.
4. Installation
• Have the device installed by a qualified person, respecting EN 60598-2-17 and all
other applicable norms.
• Make sure there is no flammable material within a 0.5 m radius of the device.
• Have a qualified electrician carry out the electric connection.
• Connect the device to the mains with the power plug. Do not connect it to a
dimming pack.
• The installation has to be approved by an expert before the device is taken into
service.
• Use the template on the packaging to determine the cutting hole. Place the template
onto the installation spot, trace the contours and cut the hole using the appropriate
tools.
• Press the two springs towards the bracket and insert the light into the hole.
• Connect a 12 VDC power supply.
5. Description
1.
reflector
2.
bracket
3.
12 VDC input
4.
spring
5.
power supply
LEDA01RGB_v4
3
HQPOWER™

Publicité

loading