Publicité
Les langues disponibles
Les langues disponibles
English
g ) Do not expose a battery pack or appliance to fire
or excessive temperature. Exposure to fire or temperature
above 266 °F (130 °C) may cause explosion.
h ) Follow all charging instructions and do not charge
the battery pack or appliance outside of the temperature
range specified in the instructions. Charging improperly or
at temperatures outside of the specified range may damage the
battery and increase the risk of fire.
i ) Have servicing performed by a qualified repair person
using only identical replacement parts. This will ensure
that the safety of the product is maintained.
j ) Do not modify or attempt to repair the appliance or
the battery pack except as indicated in the instructions
for use and care.
k ) Only for use with S003AQU1500015 charger.
Additional Safety Information
WARNING:
any part of it. Damage or personal injury could result.
• Wear protective clothing and wash exposed areas with
soap and water. Allowing dust to get into your mouth, eyes, or
lay on the skin may promote absorption of harmful chemicals.
Direct particles away from face and body.
• Air vents often cover moving parts and should be
avoided. Loose clothes, jewelry or long hair can be caught in
moving parts.
The label on your tool may include the following symbols. The
symbols and their definitions are as follows:
V ......................... volts
Hz ....................... hertz
min ..................... minutes
or DC ...... direct current
...................... Class I Construction
(grounded)
.../min .............. per minute
BPM .................... beats per minute
IPM ..................... impacts per minute
OPM .................... oscillations per minute
RPM .................... revolutions per minute
sfpm ................... surface feet per
minute
SPM .................... strokes per minute
A ......................... amperes
W ........................ watts
Wh ...................... watt hours
Ah ....................... amp hours
or AC ........... alternating current
The RBRC® Seal
Please take your spent battery packs to
an authorized BLACK+DECKER service
center or to your local retailer for recycling.
In some areas, it is illegal to place spent
battery packs in the trash. You may also contact your local
recycling center for information on where to drop off the
spent battery pack. Do not place in curbside recycling. For
more information visit www.call2recycle.org or call the
toll-free number in the RBRC® Seal.
RBRC® is a registered trademark of Call 2 Recycle, Inc.
6
Never modify the appliance or
or AC/DC .... alternating or direct
current
...................... Class II Construction
(double insulated)
n o ....................... no load speed
n ......................... rated speed
PSI....................... pounds per square inch
...................... earthing terminal
..................... safety alert symbol
..................... visible radiation–
do not stare into
the light
..................... wear respiratory
protection
..................... wear eye protection
..................... wear hearing
protection
..................... read all
documentation
..................... do not expose to rain
ASSEMBLY
WARNING:
repair the appliance.
Wall Mounting
The product can be wall mounted, if desired, using the wall
mount bracket, screws and anchors supplied. To wall mount
the vac, refer to Figures B, C, D and E.
• Figure B - Mark the location of the screw holes (within
reach of an electrical outlet for charging the vac while it is on
the wall bracket).
• Figure C - Insert the charger cord into the curved slot in
the wall mount bracket
9
(203 mm - 227 mm) excess as shown.
• Figure D - Hang the vac on the wall by placing the
opening on the base of the vac over the hooks in the wall
mount bracket as shown in Figure D.
• Figure E - Insert the jack plug
Charging the Battery
WARNING:
supplied charger.
From new, the rechargeable cells of the product need a
minimum charge time of 16 hours to ensure full power.
• The switch must be in the off ("O") position, the product
will not charge if it is in any other position.
• Figures A, F - Plug the jack plug
into the charging socket
any standard 120 Volt 60 Hz electrical outlet.
• While charging, the charger may get warm; this is perfectly
normal and safe. It is safe to leave the appliance connected
to the charger indefinitely. The charger automatically reduces
power consumption when charging is complete.
WARNING:
at ambient temperatures below 39° F (4° C) or above
104° F (40° C).
USE
Switching On and Off (Fig. G)
• Figure g - To start, slide the On/Off switch
(i.e. "O"= Off, "I" = On).
• To stop, slide the switch back.
• Return the product to the charger immediately after use so
that it will be ready and fully charged for the next use. Ensure
that the product is fully engaged with the charger plug.
Cleaning and Emptying the Product
WARNING:
Never use the vac without its filter.
nOTE: The filter is reusable; do not confuse it with a
disposable dust bag, and do not throw it away when the
product is emptied. We recommend that you replace the
filter every 6–9 months depending on frequency of use.
There are two methods of cleaning the bowl, a quick empty
method and a thorough clean method.
For a Quick Empty (Fig. H, I)
• Figure h - Press the dust bowl release button
handle and remove the dust bowl.
Do not attempt to modify or
leaving approximately 8–9 inches
into the charging socket.
11
For use only with the
11
of the charger
of the tool. Plug the charger into
3
Do not charge the battery
1
forward
Projectile/Respiratory Hazard:
2
10
on the
Publicité
