Setting Up - Radiometer Analytical CTV101 Mode D'emploi

Setting up

Setting up
Setting up
Setting up Setting up
Set up the CTV101 in a place where the heat produced can easily be
evacuated. The room temperature should not exceed 40°C.
Screw the electrode tip (6) on the electrode body (2): the available tips
are listed at the end of this manual.
Connect the EDI101 electrode, 5-pin socket to the "EDI101" socket on
the rear panel of the CTV101. Use the connecting cable supplied with
the CTV101.
Fit the EDI101 on the measurement cell. The EDI101 electrode has a
ground joint (NS 14.5/23) which enables the electrode to fit a great
majority of measurement cells.
Connect the socket (3) of the EDI101 to the working electrode terminal of
the potentiostat or polarographic analyzer.
Set the (S2)
3
Nitrogen inlet (optional but recommended
4
if working in corrosive media)
Electrode tip
switch of the CTV101 to "STOP".
8
To CTV101
"EDI101" socket
To working electrode
terminal of the potentiostat
or polarographic analyzer