Rear Panel - Radiometer Analytical CTV101 Mode D'emploi

Rear panel

Rear panel Rear panel
Rear panel Rear panel
Socket for external control (10)
This BNC socket is to be connected to an external DC voltage generator
when using the external control mode of the instrument (3-position
switch (9) of the CTV101 front panel turned to "EXTERNAL CONTROL").
. central contact: input of the generator signal
(accepted signal: DC voltage between 0 and 5 V),
. shielding: connected to the electrical zero of the instrument.
Socket for EDI101 (11)
This 5-pin DIN socket is to be connected to the EDI101 Rotating Disc
Electrode using the cable supplied with the instrument.
Pin layout:
1 3
5
4
2
The functional ground socket (12)
Non insulated socket. Can be used to shield the electrochemical cell
using a Faraday's cage for example (in this case, this socket is to be
connected to the Faraday's cage).
Power socket (13)
This socket is to be connected to a mains socket via the
115/230V/24 Vdc power adapter supplied with the instrument.
Warning: We decline any responsibility in the event of use of an adapter
other than the one provided by Radiometer Analytical.
Pins 1 and 3: motor power supply
(1 = "+" pole, 3 = "-" pole)
Pin 2: electrical ground
Pins 4 and 5: sensor (power supply and pulse output)
7
xxxRyyyNzzz xxxRyyyNzzz
MADE IN FRANCE MADE IN FRANCE RADIOMETER ANALYTICAL SAS RADIOMETER ANALYTICAL SAS
EDI101 EDI101
POWER IN POWER IN
EXT EXT
24 Vdc 500 mA 24 Vdc 500 mA
-
+
0-5 V 0-5 V