Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
5. Attach terminal box to the wall and securely tighten screws.
A
B
C
D
A. Home power supply cable
B. Black wires
C. UL listed wire connectors
D. White wires
E. Green (or bare) ground wire from home power
supply connected to green ground screw
F. Range hood power supply cable
G. Range hood power supply cable connected to
green ground screw
6. Use UL listed wire connectors and connect black wires (B)
together.
7. Use UL listed wire connectors and connect white wires (D)
together.
WARNING
Fire Hazard
Electrically ground the blower.
Use copper wire.
Connect ground wire to green ground screw in
terminal box.
Failure to do so can result in death, fire, or
electrical shock.
8. Connect green (or bare) ground wire from home power supply
to the unused green ground screw (E) in the terminal box.
9. Tighten strain relief screws.
10. Install terminal box cover.
11. Check all light bulbs to make sure they are secure in their
sockets.
12. Reconnect power.
E
G
F
Install Chimney Covers
Vented Installation - Style 1
1. Attach the vent system to the damper. Seal all joints with vent
clamp.
2. Remove the plastic covering from the chimney covers.
3. Slide the upper chimney cover over the chimney support and
attach to the top of the support using two screws provided.
A
B
C
A. Upper chimney cover
B. Lower chimney cover
C. Screw
4. Slide the lower chimney cover over the chimney support and
the upper cover. Attach to the bottom of the support using
the 2 screws provided.
Non-vented (recirculating) Installation - Style 2
IMPORTANT: For this installation, you will need Charcoal Filter
Kit Part Number 8285507.
1. Remove the plastic covering from the chimney covers.
2. Slide the upper chimney cover over the chimney support and
attach to the top of the support using two screws provided.
3. Place the diverter from the Non-vented (recirculating)
Chimney Kit over the vent motor exhaust outlet and push
down to seat on the outlet.
Check that the diverter exhaust outlets are parallel with the
vent motor sides so that they will align with the vent cover
openings in lower chimney.
A
B
A. Diverter
B. Vent motor
9
Publicité
Table des Matières
