Pfannenberg DTI 6X2E Instructions D'utilisation page 75

GB
5.2 Cleaning the cooling unit - Unit cover removal
Item Designation
1 Fastening screws
4 Bottom plate slot
Requirement
- The cooling unit is de-energized.
-
Wait for discharging phase of 5 minutes for the electrical components. Only then open the device.
Procedure
▪ Remove the fastening screws (1).
▪ Tilt the unit cover (5) forward 20° (2).
▪ Disconnect the ground cable and connecting cables from the control panel (inside) (3).
▪ Raise the unit cover about 15 mm and pull it out of the slots in the bottom plate (4).

The unit cover is removed.
Operating Manual DTS and DTI 6X2E Premium Controller X-Series (XC) 086100099e © Pfannenberg GmbH
1
5
– Unit cover removal
Figure
19
Item Designation
2 Tilting angle 20°
5 Unit cover
1
2
3
Item
3
4
Designation
Display or operating unit
Page 34 / 41