Pando E-392 Manuel D'installation page 19

INOXPAN S.L.
EN - INSTALLATION INSTRUCTIONS
• Ensure that there is a distance of 50 mm between the hob and the wall or sides.
• The hobs are classified as "Y" class for heat protection. Ideally the hob should be installed with
plenty of space on either side. There may be a wall at the rear and tall units or a wall at one side.
On the other side, however, no unit or divider must stand higher than the hob.
• The piece of furniture or the support in which the hob is to be fitted, as well as the edges of furniture,
the laminate coatings and the glue used to fix them, must be able to resist temperatures of up to
100 °C.
• Do not install the hob at the top of a non ventilated oven or a dishwasher.
• Ensure under the bottom of the hob casing a space of 20 mm to ensure good air circulation of the
electronic device.
• If a drawer is placed under the hob, avoid putting into this drawer flammable objects (for example:
sprays) or non heat-resistant objects.
• Materials which are often used to make worktops expand on contact with water. To protect the cut
out edge, apply a coat of varnish or special sealant. Particular care must be taken when applying
the adhesive joint supplied with the hob to prevent any leakage into the supporting furniture. This
gasket ensures a good seal when used in conjunction with smooth work top surfaces.
• The safety gap between the hob and the cooker hood placed above must comply with the
• Recommendations of the hood manufacturer. In the case of no instructions, a distance of
500 mm minimum should apply.
• The connection cord should not be subjected to any mechanical constraint.
• Do not use inappropriate child safety shields or hob guards. These can cause accidents.
• WARNING: Use only hob guards designed by the manufacturer of the cooking appliance or
indicated by the manufacturer of the appliance in the instructions for use as suitable or hob guards
incorporated in the appliance. The use of inappropriate guards can cause accidents.
19
EN