Num'axes Canifugue FUG1032 Guide D'utilisation page 29

• Checking and replacing battery of receiver collar
To check the condition of the battery, observe the indicator light located on the front of the receiver collar:
− flashes slowly green: battery sufficiently charged
− flashes quickly red: weak battery. Be prepared to replace battery.
Replace the battery by following the procedure indicated above (see § Fitting the battery in the receiver collar).
NUM'AXES advises to use the same type and same brand of batteries as those supplied in your new purchased
product. Other brands of batteries may not operate, or may not be completely compatible with your product.
You can purchase the suitable batteries from NUM'AXES or from your distributor.
After the battery replacement, the collar will operate according to the last selected mode.
Due to greater use during your dog's training, the first battery may not last as long as replacement batteries. Battery life
depends on how often your dog tests the boundary.
• Changing the contact points
Two different series of contact points are supplied. The length of the contact points must be sufficient to have proper contact
with the dog's skin, enabling the device to operate correctly.
If you have a long-haired dog and the short contact points fitted to the collar in the factory are inadequate, remove and replace
them with the long ones supplied with the kit. Carefully tighten them manually (do not use a key).
• How to check that your pet fencing system is functioning properly
You can check that your pet fencing system is operating correctly at any time:
− Before doing so, make sure the receiver collar is turned Off (indicator light Off).
− Fix each wire of the neon test lamp under each contact point (unscrewing them lightly and retightening them so as to pinch
the test lamp wires).
− Turn On the transmitter and the receiver collar.
− Walk up to the antenna wire holding the collar by the strap at the same height and orientation as if on your dog's neck. At
some distance from the wire depending on the settings, the collar should emit beep sounds then, as you get closer to the
wire, the test lamp should light up.
− Before disconnecting the test lamp, make sure the receiver collar is turned Off (indicator light Off).
Fitting and positioning the collar
•
Fitting and positioning are very important. In fact, these settings determine the correct operation of the product (straying
detection, transmission of the stimulations).
The position of the collar around the neck of the dog should be in the following way: The On/Off indicator light on the collar is
visible and is not in contact with the breast of the dog.
guide canifugue - FUG1032 indice B.indd 29
29
28/06/2018 14:40