Num'axes Canifugue FUG1032 Guide D'utilisation page 23

• Antenna wire
For the system to operate, the wire must be connected to the transmitter and form a continuous loop from the transmitter and
back again. The outward and inward wires must be spaced 2 meters apart to avoid cancelling the signal.
0.52 mm² or 1.5 mm² wire can be used (you can combine several wire sections).
The wire sections recommended depending on the length of the system are as follows:
− for less than 400 m of antenna wire: 0.52 mm²
− from 400 to 800 m of antenna wire: 1.5 mm²
From the transmitter, unroll the wire around the perimeter you wish to protect. To run the wire from your garage or garden
shed, pass it through a window, door or similar.
The wire can be placed on the ground, buried (maximum: 10 cm deep) or fixed to a non-metallic existing fence or wall (best
height: your dog's neck height). If you plan on burying the wire, make sure your installation is functioning properly before
doing so. You can protect the wire by running it through PVC pipe or a length of garden hose.
The wire must not be taut as variations in temperature may cause it to expand or contract. In the corners, do not make right
angles but prefer rounded corners with a large radius.
Separate the wire by at least 2 meters from a metallic gate or one meter from a metallic fence.
Do not install the antenna wire near an electrical cable, telephone cable, television cable or satellite dishes.
In order to prevent any interference, do not run the wire within 3 meters or parallel to electrical cables. If you must cross
electrical wires, telephone wires or television cables, do so at 90 degree angles.
If you need more than 100 m of antenna wire, you must connect the different lengths of wire using the supplied connectors
(the wire does not need to be stripped). You can purchase additional wire and connectors from your supplier at any time.
To ensure your dog does not receive any warning or stimulation in certain areas (e.g. between the transmitter in the garage
and the edge of your property) you have to twist the outward wire around the inward wire. The twists prevent radio waves
from being emitted (ref. Diagram 3).
Once the loop is completed and you are back to the transmitter, strip the two ends of the wire to connect them to the supplied
transmitter connector (connect each wire with each connector screw). Then, insert this connector into the antenna socket
located on the transmitter (ref. Diagram 1 – the connector is slanted. If you can't insert it, turn it 1/2 turn).
• Flags
The flags are a temporary visual aid for your dog during the training process. They enable your dog to visualize the area where
he can move freely and the boundaries he must not cross.
We recommend installing the flags at the inner edge of the warning zone at short intervals. Do not place the flags at the
antenna wire.
Once your dog is familiar with the boundaries, the flags can be gradually removed.
23
guide canifugue - FUG1032 indice B.indd 23 28/06/2018 14:40