Ryobi RBC-1000EX Manuel D'utilisation page 25

GB
F D E
PROBLEM
Line will not advance when
tap bump button.
Bump head is hard to turn.
Grass wraps around the
attachment shaft and the
trimmer head assembly.
Unit stops and will not start
again.
Waste electrical products should not be disposed of together with household waste. Please recycle where facilities
exist. Check with your local authority or retailer for recycling advice.
I P NL S DK
POSSIBLE CAUSE
1. Line is welded to itself.
2. Not enough line on spool.
3. Line is worn too short.
4. Line is tangled on spool.
Grass wrapped or built up
around head.
Cutting tall grass at ground
level.
1. Overload protection
activated.
2. Fuse from main supply
blown.
3. Unit failed.
N FIN GR HU CZ RU
English
TROUBLESHOOTING
SOLUTION
1. Lubricate with a silicone spray.
2. Install more line (Refer to "Replacing the Cutting
Line" earlier in this manual).
3. Pull lines while alternately pressing down on and
releasing bump button.
4. Remove line from spool and rewind (Refer to
"Replacing the Cutting Line" earlier in this manual).
Clean affected parts of the machine.
Cut tall grass from the top down.
1. Wait 10 minutes before restarting.
2. Check fuse.
3. Contact dealer to check damage.
DISPOSAL
19
RO PL SLO HR TR EST LT LV SK BG