Télécharger Imprimer la page

ETNA T107V Notice D'utilisation page 17

Publicité

Les langues disponibles

Les langues disponibles

Things to watch for
Clean immediately
Any spillage should be removed
n
immediately, particularly red cabbage,
apple sauce and rhubarb. These can leave
permanent spots on the enamel or on
stainless steel.
Burning in of the enamel
The burners cause the saucepan supports
n
to get extremely hot. Over time the enamel
on the support points can burn in. This
cannot be prevented and is not covered by
the guarantee.
Burner caps
Check regularly to ensure that the caps of
n
the burners are properly in position on the
burner depressions; improper positioning
can make it difficult to light the burners,
give rise to an irregular gas flame, or
damage the burner caps.
Lighting the burners
While keeping the knob of the burner held in,
turn the knob to the left and light the burner
with a match. The gas flame can now be
smoothly adjusted from high to low.
Electrical spark switch
n
Electrical spark switch (T117VW)
n
Thermocouple protection
Burner cap
This appliance is fitted with a thermocouple.
This is a thermoelectric protection system. It
ensures that the gas tap is closed if the flame
goes out.
Burner ring
Spark plug
Thermocouple
n
Burner casing
Injector
Press the desired control knob and turn it to
the left to the maximum setting. Press the
ignition until the burner ignites. If the burner
fails to light after repeated attempts, check
to ensure that the burner cap is properly
positioned.
Press the knob of burner in and turn it to the
left to the
symbol. The spark switch will
generate sparks and the burner will light
automatically. If the burner fails to light
after repeated attempts, check to ensure
that the burner cap is properly positioned.
Press the desired control knob and turn it
to the left to the maximum setting. Press
the ignition until the burner ignites. Hold the
control knob pressed in for 5 seconds.

Publicité

loading