Publicité
Les langues disponibles
Les langues disponibles
Basic Operation
Battery Power Mode LCD Data
The LCD touchscreen offers five screens of UPS and site power information when the UPS is
operating in battery power mode. When the UPS switches to BATTERY MODE, the UPS will
automatically switch to displaying the following screens. To advance to the next screen, touch
the LCD.
1
4
1
Output Voltage
2
Input Voltage
3
Load %
4
Battery Charge Level
5
Overload
Critical Fault Screens
Error Code
Critical Fault
F01
OUTPUT SHORT
F02
OVER LOAD
F03
OVER CHARGE
F04
BATTERY LOW
VOLTAGE
F05
BATTERY MODE
HIGH OUTPUT
18-09-014-933874.indb 7
2
5
Solution
Disconnect load(s) from UPS outlets. Power off UPS and
contact Tripp Lite Technical Support for assistance.
Remove excess load, check load meter on LCD for load
status.
Turn unit off, unplug UPS and contact Tripp Lite
Technical Support for assistance.
Charge UPS for 24 hours. If problem persists, replace
battery and contact Tripp Lite Technical Support if
problem persists.
Turn off power to the UPS and contact Tripp Lite
Technical Support for assistance.
7
3
9/12/2018 9:52:14 AM
Publicité
