Garland GEISER 451 G Manuel D'instructions page 27

8. If the engine does not start, move the air lever to
open and pull the starter rope until the engine
starts.
9. Regulate the accelerator so that the engine moves
at the desired speed.
6.4.4. HOT START UP
1. Open the petrol key.
2. The switch in the ¨ON¨ position.
3. Put the air lever in the close position
4. Place the accelerator lever at 50%.
5. Pull the starter rope until the engine starts holding
the machine firmly to the ground by the handle.
6. Regulate the accelerator so that the engine moves
at the desired speed.
6.4.5. ENGINE STOPAGE
1. Move the accelerator lever to its minimum.
2. Place the switch in the ¨OFF¨ position (stoppage)
3. Close the petrol key.
6.5. CHECKING POINTS AFTER START UP
Check that the pump sucks up water. Make sure that
there are no air leakages in the hose.
Check that all the racors are correctly tightened and
that there are no water leakages on the main body of
the pump, through the racors or in the impulsion hose.
Attention! If you observe that water does not reach
the pump in a short interval of time, stop the pump
to avoid breakages.
Attention! Do not fill the pump with water with the
pump running.
6.6. END OF USAGE
After using the machine, empty the water that is
inside the machine. To do this, unscrew the emptying
water screw and wait for the water to empty from the
machine. After this, screw back into place.
7. MAINTENANCE AND SERVICE
.
The objective of the maintenance and service is to
ensure that your machine works always in the best
possible conditions both in efficiency and security.
Follow the recommendations and the maintenance
periods included in this manual.
Turn off the engine before doing any
adjustments, change of accessories or storing the
machine.
Warning! Do not modify the machine. An
inadequate use of these elements can cause
PERSONAL DAMAGES AND EVEN DEATH.
Maintain the machine clean, specially the petrol
deposit area and the area near the air filter.
Any changes should be done on a flat and stable surface.
Only use original spare parts and accessories for this
machine so as to obtain the best performance from
the machine. These spare parts and accessories can
be found in the official distributors of the brand. The
use of other spare parts and accessories could result
in risks to the end user, people who are nearby and to
the machine.
Do periodic revisions to the machine to ensure the
machine is in good conditions. For an in depth revision
take the machine to your nearest after sales service.
27/104
English