Ribimex PRGE3150 Manuel D'instructions Et D'utilisation page 18

IV. GETTING STARTED
WARNING!
Do not attempt to operate the generator until assembly is complete. Failure to comply
could result in possible serious personal injury.
4.1- Unpacking
• CAUTION! Lifting hazard. This product is heavy and requires a minimum of 2 people to
lift. Lift and lower with your legs by bending at the knees, not your back, to avoid injury.
• Remove the product from packaging
• Check if the product and accessories (if any) are intact.
4.2- Assembly
Mounting of main wheels (13)
• Mount the wheel axle rod (a) on the back horizontal base bar (b) of the cradle frame and
secure with the supplied mounting braces (c), screws (d) and nuts (e).
• Mount the wheels to the ends of the wheel axle rod, then secure the wheels with supplied
nuts.
Mounting supporting legs (5)
• Mount the supporting legs to the base of cradle frame with supplied long screws (f) and nuts
(g).
• Securely fasten the screws with suitable wrench.
Mounting handles (1)
• Position the handles to the front side the cradle frame, then mount the handle with supplied
long screws (h), washers and nuts (i).
• Securely fasten the screws with suitable wrench.
Page 18 / 37