ISE SY-T2711 Manuel D'instructions page 14

Attention: Make sure all screws and nuts are tightened before Exercise
Step 1: Extend the framework
1. Take the treadmill out of the box and lay it flat on the ground.
2. Slowly stand up the machine at the direction of the arrow, as shown in the figure
below.
Step 2. Main frame assembly
1. Fasten the left and right col-
umns to the main frame with
screws shown in the figure below.
Screw A M8 * 45 and Flat Washer
B are tightened by the tool kit M5
wrench.
2. Console and handrail is folded
up against the columns, they are
connected to the columns in both
of the left and right sides by
Screw C M8 * 16 and Curved
Washer D. Then tightened with
the Toolkit M5 wrench.
SCREW PACKAGE
C
C
A
A
2
EN