Panasonic ER2302 Mode D'emploi page 6

Removing the built-in rechargeable battery
The battery in this trimmer is not intended to be replaced by
consumers. However, the battery may be replaced at an
authorized service center.
The procedure described below is intended only for removal of the
rechargeable battery for the purpose of proper disposal.
1. Disconnect the power cord from the trimmer.
2. Remove the blade from the trimmer. Remove the 2 screws (a).
3. Insert the blade of the screwdriver between (b) and (c) of the
housing. Pry apart (b) and (c).
4. Remove the battery from the chassis.
• Discharge the battery completely before removing it.
• Be careful not to short the + and – terminals of the battery after
removing it.
( a )
For environmental protection and recycling of materials
This trimmer contains a Nickel‑Metal Hydride battery. Please
make sure that the battery is disposed of at an officially assigned
location, if there is one in your country.
Please read "Information for Users on Collection and Disposal of
Old Equipment and used Batteries" on page 87.
6
( b )
(c)