Télécharger Imprimer la page

Olympus PT-047 Mode D'emploi page 48

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 62
Seal the Case
1 Close the rear lid of the Case gently.
2 Turn the open/close dial clockwise.
• The Case is sealed when the dial is turned 180 degrees.
En
CAUTION:
• If the open/close dial is not fully turned, the Case will not be sealed. This
will cause water leakage.
• Close the rear lid of the Case so that the lens cap or LCD hood strap
doesn't catch. If it catches, water leaks may result.
Check the operation of the loaded camera
After sealing the Case, check that the camera operations normally.
1 Push the ON/OFF button on the Case and confirm that the camera
turns ON/OFF.
2 Turn the mode dial on the Case and confirm that the camera mode
switches properly.
• Check if the correct mode is being switched from the LCD monitor.
3 Press the shutter lever on the Case and confirm that the camera
shutter releases.
• Also operate other control buttons on the Case and confirm that the
camera functions properly.
EN 18
Close

Publicité

loading