us_main.book.book Page 55 Wednesday, September 23, 2020 1:25 PM
Problem
Water is not
New installation or water line recently connected.
dispensing.
• Dispense 2.5 gallons of water (flush for approximately 5 minutes) to remove trapped air
The dispenser panel is locked.
• Press and hold the Lock button for three seconds to unlock the control panel and
The dispenser is not set for water dispensing.
• The dispenser can be set for ice or water. Make certain that the control panel is set for the
Refrigerator or freezer doors are not closed properly.
• Water will not dispense if any of the refrigerator doors are left open.
Water filter has been recently removed or replaced.
• After the water filter is replaced, dispense 2.5 gallons of water (flush for approximately five
Tubing connecting refrigerator to house supply valve is kinked.
• The tubing can kink when the refrigerator is moved during installation or cleaning.
The house water supply is not connected, the valve is not turned on fully, or the valve is
clogged.
• Connect the refrigerator to the water supply and turn the water shutoff valve fully open. If
Dispensing warm
Refrigerator was recently installed.
water.
• Allow 24 hours after installation for the water storage tank to cool completely.
The water dispenser has been used recently and the storage tank was exhausted.
• Depending on your specific model, the water storage capacity will range from
Dispenser has not been used for several hours.
• If the dispenser has not been used for several hours, the first glass dispensed may be
Refrigerator is connected to the hot water supply.
• Make sure that the refrigerator is connected to a cold water pipe.
and contaminants from the system. Do not dispense the entire 2.5 gallon amount
continuously. Depress and release the dispenser pad for cycles of 30 seconds ON and 60
seconds OFF.
dispenser.
proper operation. Press the Water button on the control panel to dispense water.
minutes) to remove trapped air and contaminants from the system. Do not dispense the
entire 2.5 gallon amount continuously. Depress and release the dispenser pad for cycles of
30 seconds ON and 60 seconds OFF.
Resulting in reduced water flow. Straighten or repair the water supply line and arrange it
to prevent future kinks.
the problem persists, it may be necessary to contact a plumber.
approximately 20 to 30 oz.
warm. Discard the first 10oz.
WARNING: Connecting the refrigerator to a hot water line may damage the
icemaker.
TROUBLESHOOTING
Possible Cause & Solution
55