Beeper TSX99-N Manuel D'installation & D'utilisation page 24

SYSTEM FUNCTIONS
18. PROGRAMMING OF THE TIME OF LOCKING
The function of locking of the doors is programmed in factory. The fitter must open the sliding trap door of the power station of connection to select the clamping pulse wished:
Rider connecting 1 & 2 = Impulse of 0.5 seconds, rider connecting 2 & 3 = 3.5 seconds Impulse.
19. MEMORIZING OR DESACTIVATION OF A REMOTE CONTROL
(1) In the event of loss of a remote control or if you wish to add an additional remote control, you must buy a new remote control near the engineering service (references
TSX2-TX1, TSX2-TX2), then to memorize the code of the new remote control in the system. The process of appairage is the following:
A. Appuyez on the button of training on the power station of connection, the siren will page 1 time, the LED of indication on the power station will ignite, then press 1 time on
any button of the remote control, the siren will page 2 times to indicate to you that the appairage functioned correctly. You can renew the procedure for appairer to the
maximum 6 operates by remote control.
B. Switch on, press 7 times of continuation on the off-set pushbutton, the siren will page 1 time, the LED of indication will enter in learning mode. Press on any button of the
remote control, the siren will page 2 times to indicate to you that the appairage functioned correctly.
(2) In the event of loss of remote control or if you wish to delete the code of a remote control of the memory of the system (that will prevent the use of the remote control by
an unauthorized user, which would have found the lost remote control), the continuation is a stage of the suppression.
A. Appuyez on the pushbutton which is under the trap door of the power station during 3 seconds, until the LED on the power station dies out. The siren then pages 3 times to
indicate that the codes in memory were unobtrusive (including those of the current remote control). The current remote control can be re-used on condition that Re-memorized
its code.
B. Switch on, press 7 times of continuation on the off-set pushbutton, the siren will page 1 time, the LED of indication will ignite and enter in learning mode. Press again on the
switch of priority uninterrupted during 7 times, the siren will page 3 times to indicate that the codes in memory were unobtrusive (including those of the current remote control).
The current remote control can be re-used, on condition that Re-memorizing its code.
20. LED OF INDICATION
Armed alarm: The LED flashes 2 times, then stops 1 second, then flashes 2 times, etc
Sensor of shocks activated: The LED flashes 3 times, then stops 1 second, then flashes 3 times, etc
Contact or carries activated: The LED flashes uninterrupted during 2 seconds, then stops during 2 seconds, then flashes uninterrupted during 2 seconds, etc
21. WINDOW UP OPTION
When you lock the vehicle "padlock closed", the gray wire "window up control (-)" will be active for a period of 20 seconds.
If this option is connected to your vehicle, the windows will close
automatically when locking the vehicle.
24