Beeper TSX99-N Manuel D'installation & D'utilisation page 18

BEFORE INSTALL
We thank you for taking the following advice before the installation of the system:
• The system functions under tension 12V continuous (12 V cd.). Be sure polarity of each wire.
• Check before the installation if all the elements of the vehicle function correctly such as contact & driving starting, lighting of codes, fires and
headlights, indicators, heating, air conditioning, locking of the doors,... Check after installation that all these same elements function.
• Connect the sons only by splice/welding without using thimbles. The bad contacts can create serious dysfunctions of system and of the vehicle
also.
• When you connect the general MASS of the system, it is very important that this mass is frank and completely stable (not escapes).
• Take care that all the sons passing in tight places are protected by adhesive tape to avoid any excessive torsion and degradation of the plastic
protection of the wire with risk of bad contacts.
• Take care that the sons of the system as all the accessories of security the are best dissimulated possible one in the vehicle, do not forget
never that you install a security system.
• Use a digital multimeter in order to locate each polarity of the sons, use a lamp test to locate the wire of Tachometer (if necessary).
• Take care not to disconnect the battery if the vehicle has a car radio with code.
• If the vehicle is equipped with a AIRBAG, take care not to disconnect the battery from the vehicle, nor to connect without certainty the sons.
• Withdraw the fuse of ceiling light when you install the system in order to avoid emptying the battery (open doors).
The systems BEEPER are generally installed on the multiplexed vehicles.
All the necessary information with connection are on sons with normal polarity (about) on which does not forward a data (multiplexed BUSCAN, VAN or another coding). You
should not imperatively cut or touch a multiplexed wire.
IN ALL CA, IT USELESS AND IS DISADVISED CUTTING A WIRE OF ORIGIN OF THE VEHICLE. YOU MUST ONLY MAKE ONE SPLICE AND RECOVER THE POSITIVE SIGNAL OR NEGATIVE
FORWARDING BY THIS WIRE.
MULTIPLEXED VEHICLES
18