BH FITNESS G550 Mode D'emploi page 17

-speed .- Key for increasing speed.
When pressed during exercise this
key will increase the speed of the
machine by one tenth of a kilometre
per hour. The speed will continue to
increase as long as this button is
being pressed. During the selection of
pre-programmed profiles, it is used to
move on to the next profile screen.
-enter.- Selection and validation key.
This is used during pre-programmed
profile selection to select a profile,
confirm data that have been entered
and to start the exercise. It is also
used during user profile programming
to confirm the exertion level settings
for each minute.
-pause.- Pause key. If this is pressed
during a session, the exercise is
interrupted and
chronometer is halted. To restart the
exercise chronometer
pause key
exercising. If, in pause mode, you
press the STOP key then the exercise
will be finished.
-stop.- Stop key. If this is pressed
during the session, the exercise will
finish and the belt will stop. A
summary of all the exercise data will
be displayed and it will then return to
the start screen.
-Incline V.- Decrease inclination key.
When pressed during exercise this
key will decrease the level of
inclination by one degree. Inclination
will continue to decrease as long as
this button is being pressed.
-Incline Λ.- Increase inclination key
When pressed during exercise this
key will increase the level of inclination
by one degree.
continue to increase as long as this
button is being pressed.
-quick / start.- Quick start key. When
the exercise
press
again or continue
Inclination
this key is pressed, provided that the
LED on the key is flashing, exercise
will begin in manual mode after a 3
second countdown.
STARTING.-
Switching the monitor on: Plug the
mains
machine,
socket, making sure that the voltage is
that stated for the machine and that
the socket is equipped with an earth
connection Fig.B. Next, set the switch
(b) to position [1]. Fig.A.
the
Once the monitor is on it will display
the profile and the letter "M" for
manual on the LED array (A) Fig.2,
and the welcome message on the
bottom alphanumeric screen (B).
By pressing the QUICK/START key
the machine will start in manual mode
after a 3 second countdown at a
speed of 2 km/h, by pressing the
speed
increase
will
settings. You can also increase or
decrease the speed settings by using
the numeric keys (G).
17
cable, supplied
into an electric
Fig.A
Fig.B
or speed – – – – keys you can
or decrease
with the
mains
the speed