AL-KO solo Robolinho 4100 Traduction De La Notice D'utilisation Originale page 63

Maintenance and care
9 MAINTENANCE AND CARE
CAUTION!
Risk of injury
Sharp-edged and moving
appliance parts can lead to
injury.
■
Always wear protective
gloves during mainte-
nance, care and clean-
ing work.
9.1 Cleaning
IMPORTANT!
Danger from water
Water in the automatic
lawn mower and in the
base station leads to dam-
age on electrical compo-
nents.
■
Do not spray the auto-
matic lawn mower and
base station with water.
Clean the automatic lawn mower
CAUTION!
Danger of injury due to
the cutting blade
The cutting blades are
very sharp and can cause
cutting injuries.
■
Wear protective gloves.
■
Make sure that parts of
the body do not get into
the cutting blade.
457296_b
All manuals and user guides at all-guides.com
Once a week, carry out the following:
1. Switching off the appliance.
2. Wipe off the surface of the housing with a
broom, a brush, a damp cloth or a fine
sponge.
3. Brush off the underside, mower deck and cut-
ting blade with a brush.
4. Check the cutting blade for damage. If neces-
sary, replace the following: see chapter 9.3
"Replacing the cutting blades", page 64.
Cleaning the base station
1. Regularly remove grass residues and leaves
or other objects out of the base station.
2. Wipe off the surface of the base station with
a damp cloth or a fine sponge.
9.2 Regular checks
General checks
1. Once a week, check the whole Installation for
damage:
■
Machine
■
Base station
■
Boundary cable
■
Low voltage cable
■
Transformer with power cable
2. Replace defective parts by original spare
parts from AL-KO or have them replaced by
an AL-KO service centre.
Check the rollers can move freely
Once a week, carry out the following:
1. Carefully remove grass residues and soiling
from the areas around the rollers. Use a
broom and cloth for this.
2. Check that the rollers run freely and that they
can be steered.
Note: If the rollers do not move freely or can-
not be steered, have them replaced by an
AL-KO service centre.
Check the contact surfaces on the automatic
lawn mower
1. Use a cloth to remove soiling and then lightly
grease with contact grease.
2. Rub any charring on the contact surfaces
down to the bare metal surface with fine sand
paper and then lightly grease with contact
grease.
63