AL-KO solo Robolinho 4100 Traduction De La Notice D'utilisation Originale page 58

GB
1. Place the appliance (09/1) in the base station
(09/3) so the contact surfaces of the appli-
ance touch the charging contacts of the base
station.
2. Switch on the appliance.
3. The display on the appliance shows: "Bat-
tery is being recharged". If not: see
chapter 14 "Help in case of malfunction",
page 67.
5.2 Making the basic settings
1. Fold up the cover flap of the control panel.
2. Switch on the appliance. The firmware,
code number and type are displayed.
3. In the menu for language selection, select:
"English"
4. In the "Login" > "Enter PIN" menu, enter
the pre-set PIN 0000. To do so, select the
digit with and confirm each time with
. After entering the PIN, access is en-
abled.
5. In the "Change PIN" menu:
■
Under "Enter new PIN", enter a self-
selected new four-digit PIN. To do so, se-
lect one digit in sequence with
confirm each time with
■
Under "Reenter new PIN", enter the
new PIN again. If both entries are identi-
cal, the following is displayed: "PIN
changed".
6. In the "Enter date" menu, set the current
date (format: DD.MM.20YY). To do so, select
one digit in sequence with
each time with
7. In the "Enter time" > "HH:MM" menu, set
the current time (format: HH:MM). To do so,
select one digit in sequence with
confirm each time with
The basic settings have been completed. The
"Not calibrated Press Start key" status
is displayed.
5.3 Setting the cutting height
The cutting height of the appliance is set in the
settings menu: see chapter 7.2 "Setting the cut-
ting height", page 59.
58
All manuals and user guides at all-guides.com
.
and
.
and confirm
.
and
.
5.4 Carrying out an automatic calibration
movement
Place the appliance at the starting position
(10)
1. Place the appliance at the starting position in-
side the mowing area:
■
At least 1 m left and 1 m in front of the
base station
■
Aligned with the front side to the bound-
ary cable
Starting the calibration movement
1. Check that there are no obstacles in the ex-
pected movement area of the appliance. The
appliance must be able to move over the
boundary cable with both front wheels. Re-
move any obstacles if necessary.
2. Start the appliance. The following
is shown on the display:
■
"! Caution ! Starting Motors"
■
"Calibration", "Phase [1]"
During the calibration movement
To determine the signal strength inside the
boundary cable, the appliance first moves twice
straight beyond the boundary cable and then into
the base station and comes to a stop there.
■
The "Calibration completed" message
is shown on the display.
■
The rechargeable battery is being charged.
NOTE
The appliance must come to a stop
when it moves into the base station. If
the appliance does not touch the con-
tacts when it moves into the base sta-
tion, it moves further along the boundary
cable. If the appliance moves through
the base station, the calibration proce-
dure has failed. In this case, the base
station must be better aligned and the
calibration procedure repeated.
After the calibration movement
The pre-set current mowing duration is displayed.
For all further settings, refer to see chapter 7
"Settings", page 59.
Start-up
Robolinho 4100