Mitsubishi Electric Mr. Slim PAR-SL100A-E Manuel D'utilisation page 8

4. Operation
2
5
A
B
Fig. 3-3
8
Press the
• The remote controller exits the initial setting mode.
(The air conditioner operation is stopped.)
• The transmission mark
is transmitted.
• The indoor unit beeps to confi rm that the signal trans-
mitted from the wireless remote controller has been
received by the receiver on the indoor unit. If the indoor
unit does not beep, transmit the signal again.
3
8) Operation mode setting
1
1. Press the
4
2. Press the
screen will be displayed.
3. Press the
6
(Fig. 3-3)
7
4. Press the
8
Operation mode
display A
5. Press the
setting.
4.1. Switching the unit on/off
1. Press the
• The remote controller display turns on.
2. Press the
• Each time the button is pressed, the setting changes.
* If the automatic operation is selected, cooling operation
starts if the room temperature is higher than the set
temperature and heating operation starts if the room
temperature is lower than the set temperature.
If the AUTO (dual set point) mode is enabled,
played.
When setting the AUTO (dual set point) mode, you can
set 2 temperatures (1 temperature for cooling and 1
temperature for heating).
According to the room temperature, the indoor unit oper-
ates automatically in the cooling or heating mode to keep
the room temperature within the set range.
* The AUTO (dual set point) mode cannot be used depend-
ing on the model of the connected outdoor unit.
button 2.
appears each time a signal
button 1 to stop the air conditioner.
button 8 in 5 seconds. Model setting
button 2. Operation mode A blinks.
button 7 to change setting No.
Setting Operation mode
No. B display A
01
02
03
04
button 8 in 5 seconds to complete the
button 1.
button 2.
Auto Heat Cool Dry
Setting
No. B
05
06
07
Fan
is dis-