Bosch PAM20001 Mode D'emploi page 33

Navigation
Instructions for Use
Preparing the appliance before use
Installing the air expulsion tube
Fit the air expulsion tube assembly into the
housing on the top of the appliance at the
back, Fig. 7.
Fig. 6 Fig. 7
In order to fit the expulsion tube assembly
properly in its housing, it is necessary to slide
the sleeve into the positioning slot (as shown
by the arrows on Fig. 8).
Fig. 8
The diffusion duct, Fig. 6, is added when the
tube assembly has been fitted onto the
appliance.
Housing for the
air expulsion
assembly
33
Press the "Push" tab (Fig. 9, 1) and slide out
(Fig, 9, 2) to remove the assembly from the
appliance.
Fig. 9
Installation for the dehumidification and air
purification function
Remove the diffusion duct and set the air
expulsion tube to the position shown in
fig. 10.
The expulsion tube may also be totally
dismantled if desired.
Installing the air expulsion accessories for
the air-conditioning function
There are a set of accessories used to expel
hot air (see "Description of accessories").
Installing the suction pad
Open the window slightly and position the
diffusion duct between the jamb and the
glaze frame.
Close the window as far as possible and
secure it with the suction pad supplied,
Fig. 11.
Suction pad
Fig. 10
Fig. 11