AL-KO solo T 22-111.4 HDS-A V2 Manuel D'utilisation page 40

GB
Malfunction
Lawn tractor does not
move off.
Unclean cut.
Travel drive, brake,
clutch and mower
mechanism.
12 AFTER-SALES/SERVICE
In the event of questions of warranty, repair or
spare parts, please contact your nearest AL-
KO Service Centre. These can be found on the
Internet at:
www.alko-garden.com/service-contacts
Further information on spare parts can be found
at:
www.alko-garden.com/spareparts
14 GUARANTEE
We will resolve any material or manufacturing faults on the appliance during the legal warranty period
for claims relating to faults, in accordance with our choice either to repair or replace. The legal warran-
ty period is determined by the legislation of the country in which the appliance was purchased.
Our warranty promise applies only if:
■
These operating instructions are heeded
■
The appliance is handled correctly
■
Original spare parts have been used
The guarantee excludes:
■
Paint damage that can be attributed to normal wear and tear
■
Wear parts that are marked with a frame
■
Internal combustion engines (these are covered by the guarantee provisions of the corresponding
engine manufacturers)
The guarantee period commences with purchase by the first end user. The date on the proof of pur-
chase is decisive. In the event of a guarantee claim, please take this guarantee declaration and the
original proof of purchase, and contact your dealer or the nearest authorised customer service centre.
This statement does not affect the purchaser's statutory claims for defects against the vendor.
40
Cause
With hydrostat drive: no travel
drive.
Blade worn, blunt.
Incorrect cutting height.
Engine speed too slow.
Ground travel speed too high.
Different tyre pressures on the
wheels.
xxxxxx (x)
Remedy
Move bypass lever to operating position
(see chapter 6.3 "Pushing the lawn trac-
tor (10, 11)", page 32).
Renew or regrind blade. Reground
blades must be rebalanced (customer
service workshop)!
Correct the cutting height.
Set maximum engine speed.
Reduce ground travel speed.
Inflate to correct air pressure. Read off
correct tyre pressure on tyre.
Have the check performed only in a cus-
tomer service workshop!
13 INFORMATION ON THE
DECLARATION OF CONFORMITY
We hereby declare, as the exclusively responsi-
ble party, that this product in its marketed form
meets the requirements of the harmonised EU
Directives, EU safety standards and the product-
specific standards. The Declaration of Conformity
forms part of the operating instructions and is in-
cluded with the machine.
The warranty becomes void in the case of:
■
Unauthorised repair attempts
■
Unauthorised technical modifications
■
Non-intended use
on the spare parts card
After-Sales/Service
494344_a