LD Systems U500 IEM Serie Manuel D'utilisation page 13

POCKET RECEIVER OPERATION
To establish a radio connection between transmitter and receiver, the channel group and channel number or the radio frequency of the two devices
must match.
When putting the wireless transmission system into operation, be sure to position the receiver in direct line of sight with the transmitter.
MAIN DISPLAY
Shortly after switching on the pocket receiver, the main display A appears with the following information: Individual user name, operating mode,
radio signal reception strength, battery status, frequency group and channel.
Alternatively, the main display B is shown with the radio frequency in MHz and the level of the left and right audio signal with peak display (PK).
Brie昀氀y press the  button to switch between the two display variants.
Receiving strength of the radio signal
SET VOLUME BALANCE (BALANCE / FADER)
MONO mode: Activate MONO mode in the transmitter. The two channels left and right are mono summed. In the receiver, the mono signal can
be shifted to the left or right in BALANCE. Press SEL (MENU) for about 2 seconds to enter the main menu, then, if not already selected, press SEL
repeatedly to select BALANCE (highlighted) and press  to con昀椀rm. Now move the signal to the left or right as desired by pressing  (repeatedly
if necessary). To exit, press SEL, select EXIT again by pressing SEL and press  to con昀椀rm. The main display will automatically appear after approxi-
mately 5 seconds of inactivity.
STEREO mode: Activate STEREO mode in the transmitter. A stereo signal available to the transmitter is also reproduced in stereo in the pocket
receiver (deactivate FOCUS mode – FOCUS OFF). In the receiver, the balance between the left and right channel can be set in the menu item BALANCE.
Press SEL (MENU) for about 2 seconds to enter the main menu, then, if not already selected, press SEL repeatedly to select BALANCE (highlighted)
and press  to con昀椀rm. Now adjust the balance as desired by pressing  (repeatedly if necessary). To exit, press SEL, select EXIT by pressing SEL
again and press  to con昀椀rm. The main display will automatically appear after approximately 5 seconds of inactivity.
Individual user name
Battery status
Main display A
Operating mode Mono / Stereo
Frequency group
Frequency channel
Main display B
Radio frequency
Left channel
Audio signal level / peak (PK)
Right channel
13