LD Systems U500 IEM Serie Manuel D'utilisation page 11

EQ SETTINGS
BASS EQ
MIDDLE EQ
TREBLE EQ
EXIT EQ
SETT.
Exit sub-menu (press encoder)
EXIT AUDIO SETT.
INDIVIDUAL USERNAME (NAME)
Press the transmitter's rotary-push encoder (MENU) to enter the main menu, then turn the encoder to select NAME (highlighted) and press the
encoder to con昀椀rm. Now set the individual name (up to 8 digits) by turning the encoder to select a letter, character or number for the 昀椀rst digit of
the name and con昀椀rm by pressing the encoder. This is followed by the input for the second digit and so on. Once the name is complete, press the
encoder again to con昀椀rm. Brie昀氀y (!) press POWER to return directly to the main display; after about 12 seconds of inactivity the main display will
appear automatically.
SET THE DISPLAY BRIGHTNESS (BRIGHTNESS)
Press the transmitter's rotary-push encoder (MENU) to enter the main menu, then turn the encoder to select BRIGHTNESS (highlighted) and press
the encoder to con昀椀rm. Select the 3-step display brightness (HIGH = high, MID = medium, LOW = low) by turning the encoder as desired and press 2x
on the encoder to con昀椀rm. Brie昀氀y (!) press POWER to return directly to the main display; after about 12 seconds of inactivity the main display will
appear automatically.
LOCK OPERATING ELEMENTS (PANEL LOCK)
Press the transmitter's rotary-push encoder (MENU) to enter the main menu, then turn the encoder to select PANEL LOCK (highlighted) and press the
encoder to con昀椀rm. To lock the control elements, select ON by turning the encoder and press the encoder twice to con昀椀rm. Brie昀氀y (!) press POWER
to return directly to the main display; after about 10 seconds of inactivity the main display will appear automatically. If one of the POWER controls or
the MENU rotary-push encoder is pressed, "PANEL LOCK ON" brie昀氀y appears on the display and setting changes are blocked. To unlock the controls,
press and hold the rotary-push encoder for about 2 seconds and select OFF in the PANEL LOCK menu item to permanently allow operation using the
controls.
G: +/- 15dB
f: 60Hz / 80Hz / 100Hz / 200Hz
G: +/- 15dB
f: 500Hz / 1000Hz / 1500Hz /
2500Hz
Q: 0.50 / 0.75 / 1.00 / 1.25
G: +/- 15dB
f: 10.0kHz / 12.5kHz / 15.0kHz
/ 17.5kHz
Exit equalizer menu (press encoder)
Bass frequency gain from -15dB to +15dB
Setting the bass frequency
Centre frequency gain from -15dB to +15dB
Setting the centre frequency
Setting the Q-factor
Treble frequency gain from -15dB to +15dB
Setting the treble frequency
11