Garland 105 E Manuel D'instructions page 29

6.3.1. PLACING THE MACHINE
Ensure that you place the machine in a vertical and
stable position. It should not be placed near a wall
and on a floor that is not too hard and where you have
sufficient place to be able to work.
6.3.2. VERIFICATION OF THE BLADES AND THE
HOPPER OF THE SHREDDER
Check that there are no elements inside the shredding
channel and that the blades are correctly installed.
6.3.3. CHECKING THE ELECTRICAL CONNEXION
Verify the connecting base and the cable extension
and ensure that they are in a perfect state and that
they comply with the required normative and the
necessary requirements for this machine.
Check the cable and the cable extension is behind the
machine and clear of the work area.
6.3.4. CHECKING THE OPENING KNOB
Verify the connecting base and the cable extension
and ensure that they are in a perfect state and that
they comply with the required normative and the
necessary requirements for this machine.
Check the cable and the cable extension is behind the
machine and clear of the work area.
Cover
6.4. START UP AND STOPPAGE
Start up of the machine:
Place the switch in the ¨I¨ position.
The blades of the shredder will start
functioning.
Stopping the machine:
Place the switch in the ¨O¨ position. The engine of the
machine will stop and after a few seconds the blades
will stop as well.
After disconnecting the machine, the blades keep
turning for a few seconds due to the inertia effect.
Wait for the blades to stop before connecting the
machine again. Do not connect and disconnect the
machine in short intervals.
Note: This shredder has a security device that will
stop the machine in the following situations:
- If too much material is accumulated in the cutting
blades.
- If the material being shredded is too resistant for
the engine capacity.
- When there is an undue resistance on the blades.
If you detect that the machine does not start when
the switch is placed in the ¨I¨ position check that the
blades are clean and with no elements blocking the
blades and press the restart button.
6.5. CHECKING POINTS AFTER START UP
Check that the shredder once started but with no work
load starts correctly, the engine runs smoothly and
the blades do not hit against any element. If you hear
any strange noises or you detect that the machine
Opening
does not work properly, stop the machine and check
knob
if there are residues or other strange elements in the
machine. If the problems persist, take the machine to
your nearest authorised after sales service.
29/112
English