Mounting Material; Technical Data - Hornbach 5905357 Manuel D'installation Et De L'utilisateur

Mounting material

A fully extracted awning has to withstand extreme
loads at its fastenings. Depending on the wall type
at the installation site, the correct fastening must be
selected in order to ensure a secure fixation.
The table below provides a basic recommendation
of fastenings for different wall types, but a specialist
should be consulted in order to figure out, which fas-
tening is the appropriate one. He will also be able to
inform about the wind resistance class the awning can
withstand after the installation.
WALL TYPE
Concrete
Concrete / C20-C25
Solid brick
Clay brick / MZ
Sand-lime brick / KS
Perforated brick
Clay brick / HLZ
Sand-lime brick / KSL
Aerated concrete
Gas concrete / PB2
Cavity wall
For every mounting material, the specifications of the fastening manufacturer must be ob-served, e.g. drill
sizes, distances to edges, tensioning torques, drying times etc.

Technical data

MODEL 5905357
Max. width 1950 mm
Max. extension
1550 mm
Weight fabric
280 g/m²
Weight complete
21 kg
230 V ~ 50 Hz
Power supply
Power consumption 198 W
Degree of protection IPX4
LOCATION FASTENING
Ceiling e.g. TOX Anchor bolt S-Fix Pro 1 A4
Ceiling / insulated e.g. TOX Thermo Proof Plus
Wall e.g. TOX Anchor bolt S-Fix Pro 1 A4
Wall / insulated e.g. TOX Thermo Proof Plus
Wall e.g. TOX Masonry Set Wallix
Wall / insulated e.g. TOX Thermo Proof Plus
Wall e.g. TOX Masonry Set Wallix
Wall / insulated e.g. TOX Thermo Proof Plus
Wall e.g. TOX Masonry Set Wallix
Wall / insulated e.g. TOX Thermo Proof Plus
Wall / insulated e.g. TOX Thermo Proof Plus
WARNING
5905358
3950 mm
3050 mm
280 g/m²
40 kg
230 V ~ 50 Hz
198 W
IPX4
WARNING
To meet the wind resistance class mentioned in
the declaration of conformity, the installed awn-
ing needs to fulfil these requirements:
•
The awning is installed with the recommended
type and number of brackets.
•
The awning is installed under consideration of
the given fastening pull-out forces.
•
The instructions of the fastening manufacturer
have been respected during installation.
The combination of wall type and mounting mate-
rial used at your installation site might result in a
lower wind resistance class for your awning.
6145088
5000 mm
3050 mm
280 g/m²
45 kg
230 V ~ 50 Hz
205 W
IPX4
ENGLISH | 119