Publicité
Les langues disponibles
Les langues disponibles
3. Start-up
!
N.B., before this step
Ensure that all the electrical elements, wires, sensors etc.
are connected. Otherwise, the sensor and motor functions
will not be taken into account.
Step 1a: Pairing the control and the remote
control
1 Switch on the appliance
or
i
– The 3 LEDs come on
– The red LED is steady after a few seconds
2 Remove the black protective cap from the pairing button
3 Press
for approximately 6 seconds until the next screen
appears
4 Using the tool provided, gently press the button for 5 seconds
then release.
i
The green and orange LEDs come on
•
or
• Press
to pair the board
OK
i
The red LED becomes steady. The screen displays OFF
and turns off. Pairing is complete.
Status of control LEDs
• Green LED = Operating
• Orange LED = communication or pending pairing
• Steady red LED = conditioner stopped
• Flashing red LED = error
Step 1b: Resetting the system with
the remote control
Press simultaneously
+
10 seconds
Step 2: Starting up
1 Start up the appliance with the remote control
Press
for 2 seconds
The appliance will start up. If the
flashing, the appliance is in preparation mode, which takes
24 hrs.
2 Cutting short the 24-hour preparation period**
Press and hold down
or
will become steady. The appliance starts in heating
or cooling mode. If the setting is the same as the temperature in
the cellar, the screen will display no operating mode.
** It is best to allow the appliance to have the full 24 hours for
preparation.
Press
OK
or
indicator lights are
7
Publicité
