Troubleshooting; Disposal And Recycling - Kerbl BigBag Mode D'emploi

Maintenance work
Check safety equipment
All screw connections must be checked for
secure fastening
Functional test
General instructions:
• For work devices, check screw connections after the first 5 hours of operation
• If necessary, re-tighten all loose screw connections
Check safety equipment
All devices for stopping in an emergency and safety devices must be tested individually and separately from each other. In the event of
faulty safety devices, the packing system must be shut down immediately and secured against re-use.
Attention - danger of damage!
Road salt is very aggressive and can damage the corrosion protection.
Therefore in winter:
• Wash the device more often
• Carefully wash off road salt residues
• Check corrosion protection more frequently and, if necessary, have it renewed

6.3 Troubleshooting

Take special care when correcting errors!
• Fault: Slider cannot be opened or closed
• Remedy: Check the screw, replace or retighten if necessary
Storage conditions
The dosing device must be stored horizontally. Never store it with the tip pointing upwards, otherwise there is a high risk of injury. The protective
cap on the tip may only be removed during commissioning.

6.4 Disposal and recycling

Separate machine parts and electronic components by type and dispose of them properly. Separate all parts, auxiliary and operating
materials of the machine according to type and dispose of them in accordance with local regulations and guidelines.
If you have any questions regarding disposal/recycling, please contact the manufacturer!
Interval
1 x annually Daily 20 hours of operation
x
x
29
100 hours of
As required
operation
x