SPM SP Série Manuel D'utilisation Et D'entretien page 33

- Unscrew the security knob in the direction of
the arrow (threading on left), then pull out the
mixing unit, the bell shaped seal and the bowl
gasket on the back (fig.16).
- Remove the drip tray pulling it outward
(fig.17).
Avoid the use of abrasive cleaners that can
damage the finish. Do not put the parts in a
dishwasher. Dishwasher may damage
some parts such as the clear plastic bowls
and auger gears.
- Thoroughly wash all the removed components
with hot water and mild dishwashing detergent,
but do not use abrasive detergents or powders
that can damage the bowl.
®
- Bring KAY-5 Sanitizer/Cleaner with a 100ppm
dilution (1 Oz packet of KAY-5
water) (the sanitizing product shall comply with
40 CFR §180.940).
!IMPORTANT!
The type and concentration of sanitizing
agent shall comply with 40 CFR §180.940
- Rinse well and then place all the components
in the sanitizer solution; for proper sanitizing
the parts must remain fully plunged as
recommended by the sanitizer manufacturer
(KAY-5 sanitizer suggest at least 1-2 minutes).
IMPORTANT
Carefully follow the instructions of the
sanitizer manufacturer with regard to
timing and method of use.
- Once the correct times for sanitising have
been respected, remove and dry all components
on a clean surface. DO NOT RINSE.
- Thoroughly wash the evaporator and the drip
tray surfaces with a sponge soaked with the
sanitizer (see fig.18), leave at least 1-2 minutes
and let it dry, do not rinse.
Data di emissione: Dicembre, 2018
Caution
®
+2 ½ gallons of
Revisione: 1
Fig. 16
Fig. 17
Fig. 18
Pag. : 33/60