Connection To The Power Supply Mains; Important - SPM SP Série Manuel D'utilisation Et D'entretien

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

7. CONNECTION
SUPPLY MAINS
FOR SERVICEMAN ONLY
Before fitting the plug in the power supply
socket,
for
your
mentioned in the previous paragraph, please
read the following precautions.
-
The
machine's
guaranteed when it is connected to a suitable
earth system, structured as provided by the
national
safety
current
Therefore, the manufacturer cannot be held
responsible for any damage due to failure of the
grounding system of the machine.
- Always verify electrical specifications on the
data
plate
of
each
specifications always replace the information of
this manual.
- For a safe and correct installation, it is
essential to provide a suitable socket controlled
by a thermal cut-out switch whose contacts are
at least 3 mm apart, in accordance with the
current national safety regulations (see fig.3).
- Never use extensions or multiple adaptors.
- Check the power lead along its entire length to
make sure it is not crushed in any way.
- To unplug the device, first disconnect the
power supply with the switch, then grip the plug
and gently pull it out.

Important

IF THE POWER CABLE IS DAMAGED, IT MUST
BE REPLACED BY THE MANUFACTURER, ITS
AFTER SALE SERVICE OR BY QUALIFIED
PERSONNEL, TO PREVENT ANY POSSIBLE RISK.
Data di emissione: Dicembre, 2018
TO
THE
POWER
own
safety,
as
electrical
safety
is
regulations
machine.
Data
already
only
(fig.3).
plate
- If required by local regulations, it is
possible to have the appliance permanently
connected to electrical power supply, ref.
National Electrical Code (NEC) and NFPA
70. If this is the case, it is necessary to
remove the right side panel, disconnect the
power cable from the machine wiring,
remove it from the machine and replace it
with the permanent cable by respecting the
local codes.
Revisione: 1
Fig. 3
Pag. : 27/60

Publicité

Table des Matières
loading

Table des Matières