Mastervolt Windmaster 500 Manuel D'utilisation page 5

ENGLISH
Max Input Voltage
Max Input Current
Nom Input Power
Safety Max Short Circuit
• Contact an installer if the wind system does not
comply with the stipulations mentioned above.
Due to possible high voltages installation and
modification may only be carried out by a
qualified electrician who is familiar applicable
regulations and standards.
• Install the Windmaster 500 according to the
instructions stated in this manual.
• Be
sure that
disconnected from the grid during installation.
This can be done by removing the fuse of the
corresponding branch
distribution board.
• Connections and safety features must be
executed according to the locally applicable
regulations.
• The
Windmaster
accordance with the specifications as stated on
page 14.
• Never open the housing as high voltages may
be present inside!
Choosing the location to install
Obey the following stipulations during installation:
• The Windmaster 500 is suited for indoor use
only.
• Ambient temperature: -20 ... 50°C; (power
derating above 40°C), Humidity: 0-90% non
condensing.
• Choose an optimal location to avoid long DC
and / or AC wiring and minimize energy loss.
• Do
not install
environments with heavy dust development or
humidity.
• If the Windmaster 500 is installed in the
immediate vicinity of living areas, take into
account that it produces a slight noise level
when operating.
• Mount the Windmaster 500 vertically on a solid,
non-resonating, wall.
• Mount the Windmaster 500 in such a way that
obstruction of the airflow through the ventilation
openings is prevented.
• No objects must be located within a distance of
20 cm around the Windmaster 500.
• Multiple Windmaster 500 may be mounted next
to each other, not above each other. Minimum
spacing: 20 cm.
150 V
550 Wdc
12 A
the Windmaster 500
circuit at the
500 must be used
the Windmaster 500
USERS MANUAL WINDMASTER 500
Things you need to install the Windmaster 500
Make sure you have all the parts you need to install
8 A
the Windmaster 500:
• The Windmaster 500;
• Two
Windmaster 500. Maximum diameter: 4.5 mm.
Use mounting materials which are suitable to
carry the weight of the Windmaster 500;
• Tools to fix the screws / bolts with plugs into the
wall (screwdriver, drilling machine, a set of drills,
a pencil).
Directions for installation
The Windmaster 500 is equipped with a so called
is
"anti-islanding safety device". It ensures immediate
switch off in case of grid failure. European
countries maintain different regulations with regard
AC
to anti-islanding devices and the supply of energy
back to the utility grid in general.
In some countries one single Windmaster 500 may
be connected to an existing electricity branch circuit
in
which is fused with 16 Amp. In other countries
different restrictions apply. Please acquaint yourself
with the local regulations on this issue!
The Windmaster 500 is sold as a part of a system.
Your system vendor will provide the Windmaster
500 with the appropriate settings for the local
electrical grid. Never connect the Windmaster 500
to a utility grid which is not suitable for use with the
apparatus!
During installation you can check by means of the
LED-indicator whether the installation is done
properly. This check can only be carried out when
sufficient wind power is present.
Although the Windmaster 500 is protected against
in
wrong polarity, the positive (+) and negative (–) of
the wind turbine connections should not be
exchanged.
Install the product according to the instructions
stated on page 3 and 4.
screws (with plugs) to mount the
5