Simons Voss Technologies Digital SmartHandle AX Panic bar Guide Abrégé page 58

11. Installing the fitting for BKS
16. Screw the dummy cylinder firmly into place (PH2,
torque 1.1 Nm).
43
Fitting is now installed.
9
11. Installing the fitting for BKS
Door pre-drilled.
ü
PH2 screwdriver at hand.
ü
TX15 screwdriver at hand.
ü
Vernier calliper at hand.
ü
Saw at hand.
ü
1. Measure the door thickness.
26
2. Order the L1 screw of the appropriate length from
BKS.
45
46
3. Mark the sawing points on the L2 screws.
47
4. Determine the length X, depending on the panic bar
type.
48
5. Mark the sawing point on the spindle.
49
6. Use a suitable saw to cut the screws and spindle.
50
7. Insert the sleeve nuts into the adapter plate.
30
8. Place the adapter plate on the electronic fitting.
31
9. Align the holes in the adapter plate with the
threads in the fitting.
10. Fasten the adapter plate firmly in a criss-cross se-
quence (PH2, torque 1.1 Nm).
32
33
11. Insert the spindle with the pin side into the fitting.
34
12. Insert the fitting with adapter plate, spindle and es-
cutcheon base into the door.
56
58 / 104
13. Screw the fitting into place in the centre as de-
scribed in the BKS documentation (use the L1
screw and the wood screw ordered from BKS).
57
14. Screw the escutcheon base to the assembly using
the L2 screws (PH2, torque: 1.1 Nm).
58
15. Insert the dummy cylinder.
NOTE
Feed the blank cylinder into the hole using a screw-
driver
It is difficult to position the blank cylinder correctly, es-
pecially in thick doors.
1. Insert a screwdriver into the hole in the blank cylin-
der.
2. Position the blank cylinder using the screwdriver.
39
16. Place the escutcheon cover on the escutcheon
base.
60
17. Push the handle onto the outer fitting.
61
18. Firmly fasten the grub screw on the outside handle
(TX15; torque: 5.0 Nm).
62
19. Screw the dummy cylinder firmly into place (PH2,
torque 1.1 Nm).
63
9 Fitting is now installed.
12. Removing the fitting
ü 1.5 mm hexagonal wrench available.
1. Remove the fitting in the reverse order to installa-
tion.
2. Insert a 1.5 mm hex key into the hole in the spindle
mount in the fitting.
64
3. Bend the hex key to the side where the hole is loc-
ated while pulling on the outside handle.
65
Fitting is now removed.
9
Digital SmartHandle AX Panic bar
EN