Simons Voss Technologies Digital SmartHandle AX Panic bar Guide Abrégé page 57

Digital SmartHandle AX Panic bar
4. Insert the spindle into the mortise lock.
3
5. Place the drilling template on the spindle.
4
6. Align the drill template vertically using the printed
scale.
7. Use the distance you measured previously to de-
termine where the points need to be drilled.
8. Mark the points to be drilled on the door.
17
9. Remove the drilling template.
6
10. Remove the spindle.
19
11. Remove the mortise lock (PH2).
20
12. Drill the required holes.
21
13. Fit the mortise lock (PH2).
22
9. Programming the fitting
Programme the fitting before installation. You can use
different programming devices, depending on the
product family.
23
24
25
10. Installing the fitting for CISA
ü Door pre-drilled.
ü PH2 screwdriver at hand.
ü TX15 screwdriver at hand.
ü Vernier calliper at hand.
ü Saw at hand.
1. Measure the door thickness.
26
2. Mark the sawing points on the screws and spindle.
27
28
3. Use a suitable saw to cut the screws and spindle.
29
EN
4. Insert the sleeve nuts into the adapter plate.
30
5. Place the adapter plate on the electronic fitting.
31
6. Align the holes in the adapter plate with the
threads in the fitting.
7. Fasten the adapter plate firmly in a criss-cross se-
quence (PH2, torque 1.1 Nm).
32
33
8. Insert the spindle with the pin side into the fitting.
34
9. Insert the fitting with the adapter plate and spindle
into the door.
35
10. Screw the fitting firmly into place in the centre
(PH2, torque 1.1 Nm).
36
11. Screw the adapter plate firmly into place below the
keyhole (PH2, torque 1.1 Nm).
37
12. Fasten the wood screw as described in the CISA
documentation.
38
13. Insert the dummy cylinder.
NOTE
Feed the blank cylinder into the hole using a screw-
driver
It is difficult to position the blank cylinder correctly, es-
pecially in thick doors.
1. Insert a screwdriver into the hole in the blank cylin-
der.
2. Position the blank cylinder using the screwdriver.
39
40
14. Push the handle onto the outer fitting.
41
15. Firmly fasten the grub screw on the outside handle
(TX15; torque: 5.0 Nm).
42
9. Programming the fitting
57 / 104