Allow the water to drip off the test
2.
strip.
a The test strip will indicate the water
hardness after 1 minute.
If a water softening system is in-
3.
stalled in your house, select
"Softening system".
Press
or
4.
shows the required water hard-
ness.
The table shows allocation of the
levels to the different degrees of
water hardness:
Level German
degrees in
°dH
1
1-7
2
8-14
3
15-21
1
4
22-30
1
Factory setting
Press
.
5.
Check whether the water tank has
6.
been filled.
Check whether the bean container
7.
has been filled.
Press
.
8.
a The appliance is rinsed.
7.6 Water filter
You can use a water filter to minimise
limescale deposits and reduce impur-
ities in the water.
Inserting and activating the water
filter
ATTENTION!
Possible damage to the appliance
due to limescale build-up.
Change the water filter in good
▶
time.
Change the water filter after
▶
2 months at the latest.
until the display
Total hard-
ness in mmol/
l
< 1.3
1.3-2.5
2.5-3.8
> 3.8
Observe the display messages.
▶
Note: If "Replace water filter" is
shown on the display, replace the
water filter.
If you are not inserting a new filter,
select "No filter" and follow the in-
structions on the display.
Immerse the water filter in a glass
1.
of water and press the sides to-
gether lightly until no more air
bubbles rise to the surface.
→ Fig.
5
Press
2.
Use
or
3.
ter" and press
Use
or
4.
ter" or "Replace water filter" and
press
.
Note: If you are not inserting a new
5.
filter, select "No filter" in the menu
settings.
Press the water filter firmly into the
water tank.
→ Fig.
6
Fill the water tank up to the "max"
6.
mark and press
Remove the milk container on the
7.
left of the appliance.
Place a container with a capacity
8.
of 1 litre under the outlet system
and press
a The filter will be rinsed and the fol-
lowing message displayed: "Rins-
ing complete.".
a The appliance is ready to use.
Tips
¡ You should also change your wa-
ter filter for reasons of hygiene.
¡ With a water filter you need to de-
scale your appliance less fre-
quently.
first time en
.
to select "Water fil-
.
to select "New fil-
.
.
49