Tanaka TCS 33EDT Mode D'emploi page 6

English
MEANINGS OF SYMBOLS
NOTE: Some units do not carry them.
Symbols
WARNING
The following show symbols used for the machine. Be sure that you understand their meaning before use.
It is important that you read, fully understand and
observe the
warnings. Careless or improper use of the unit may
cause serious or fatal injury.
Read, understand and follow all warnings and
instructions in this manual and on the unit.
Always wear eye, head and ear protectors when using
this unit.
Warning, kickback danger. Be careful of possible
sudden and accidental upward and/or backward
motion of the guide bar.
One-handed usage not permitted. While cutting, hold
saw fi rmly with both hands with thumb fi rmly locked
around front handle.
The saw is specially designed for tree service and
therefore shall be used by trained operators only, in
off -ground work in trees.
It is important that you wear the protective clothing for
feet, legs, hands and fore-arms.
Chain brake
Choke - Run position (Open)
Choke - Choked position (Closed)
Contents
WHAT IS WHAT? .............................................................................. 6
WARNINGS AND SAFETY INSTRUCTIONS .................................. 7
SPECIFICATIONS ............................................................................ 9
ASSEMBLY PROCEDURES ............................................................. 9
OPERATING PROCEDURES ......................................................... 10
MAINTENANCE .............................................................................. 12
Parts breakdown
5
(Original instructions)
following safety precautions and
On/Start
Off /Stop
Emergency stop
Fuel and oil mixture
Chain oil fi ll
Carburetor adjustment - Idle speed
Carburetor adjustment - Low speed mixture
Carburetor adjustment - High speed mixture
Hot surface