Publicité
Les langues disponibles
Les langues disponibles
Problem
I cannot activate the
AquaClean water filter
and the machine asks
for descaling.
The new water filter
does not fit.
The machine is making
a loud noise.
Technical specifications
The manufacturer reserves the right to improve the technical specifications of the product. All the
preset quantities are approximate.
Description
Size (w x h x d)
Weight
Power cord length
Water tank
Coffee bean hopper capacity
Coffee grounds container capacity
LatteGo (milk container) capacity
Cause
The filter has not been installed
or replaced in time after the
AquaClean water filter light
started to flash. This means
your machine is not completely
limescale free.
You are trying to install
another filter than the
AquaClean water filter.
The rubber ring on the
AquaClean water filter is not in
place.
It is normal that your machine
makes noise during use.
The AquaClean water filter was
not prepared properly and air
is now drawn into the
machine.
The water tank is not fully
inserted and air is drawn into
the machine.
Solution
Descale your machine first and then
install the AquaClean water filter.
Only the AquaClean water filter fits
into the machine.
Place back the rubber ring on the
AquaClean water filter.
If the machine starts to make a
different kind of noise, clean the brew
group and lubricate it (see 'Lubricating
the brew group').
Remove the AquaClean water filter
from the water tank and properly
prepare it for use before you place it
back. See chapter 'AquaClean water
filter' for step-by-step instructions.
Make sure the water tank is in the
correct position: remove it and insert it
again pushing it as far as possible.
Value
247x366x434 mm
7 - 7.5 kg
1000 mm
1.8 litres, removable
275 g
12 pucks
250 ml
English
25
Publicité
