Publicité
Les langues disponibles
Les langues disponibles
English
20
Warning
Solution
icon
The alarm light is flashing
-
The brew group is not in place or not placed correctly. Remove the brew group
and make sure it is locked into place. See chapter 'Removing and inserting the
brew group' for step-by-step instructions.
-
The brew group is blocked. Remove the brew group and rinse it with water
under the tap. Then lubricate the brew group and place it back into the
machine. See chapter 'Cleaning and maintenance' for step-by-step
instructions.
The alarm light is on and the start light flashes.
Some air is trapped inside the machine. To release the air from the machine, fill
the water tank with water, place a cup under the classic milk frother and press the
flashing start/stop button.
Be careful: small jets of hot water will be dispensed from the classic milk
frother to release the air.
AquaClean light is flashing: place or replace the AquaClean water filter and
activate it. See chapter 'AquaClean water filter' for step-by-step instructions.
Descaling light is on continuously: Descale the machine.
The lights in the drink icons light up and go out one by one.
The machine is heating up and/or trying to release the air that was drawn into the
machine. Wait until all drink lights light up continuously.
The lights of all warning icons are flashing.
Reset the machine by unplugging it and plugging it back in. Before switching the
machine back on, follow these steps:
-
Remove the AquaClean water filter from the water tank.
-
Place back the water tank. Push it into the machine as far as possible to make
sure it is in the right position.
-
Open the lid of the pre-ground coffee compartment and check if this is
clogged with coffee powder. To clean it, insert a spoon handle into the pre-
ground coffee compartment and move the handle up and down until the
clogged ground coffee falls down (Fig. 30). Remove the brew group and
remove all ground coffee that has fallen down. Place back the clean brew
group.
-
Switch the machine back on.
If the problem is solved the AquaClean filter was not prepared well. Prepare the
AquaClean filter before placing it back by following steps 1 and 2 in chapter
'Activating the AquaClean water filter (5 min).
If the lights continue to flash, the machine could be overheated. Switch the
machine off, wait 30 minutes and switch it on again. If the lights are still flashing,
contact the Consumer Care Center in your country. For contact details, see the
international warranty leaflet.
Publicité
