BorMann PRO BBC8010 Mode D'emploi page 4

EN
Power supply to 12V vehicle products or 12V electronics
1. Plug the optional switch cable to 12V 2A output port.
2. Connect the optional switch cable and 12V vehicle product or 12V electronics.
3. Press the switch button to power supply.
LED illumination
Press the switch button 3 seconds to start the LED illumination and then 4 modes of LED light appear in sequence (normal, strobe, SOS, Off) if you press
lightly.
FAQ
Q. HOW to turn Off this appliance?
A. This appliance will power off automatically when no load or charging is complete.
Q. How many times can this appliance charge for my mobile phone?
A. 7 times at least for iPhone4 mobile phone.
Q. How long will this appliance take to charge my mobile phone full.
A. Approx. 1 hour.
Q. HOW long Will this appliance on a full charge to supply the Notebook?
A. 2-3 hours.
Q. How many times can this appliance on a full charge to start the vehicle?
A. Approx. 20 times.
Q. HOW long Will the power Of battery Of this appliance remain?
A. 3-6 months, however, we suggest you recharge it every 3 months.
Troubleshooting
Problem
Jump Starter is still not full
charged while its 5 indicator
lights are solid
No response when you
press the switch button
Jump Starter is a bit hot
when charging for Notebook
4
Cause
60% charging for longer
storage of Jump Starter when
no usage
Low voltage protection of
Jump Starter is activated
The charging current is a bit
high (3.5A)
Solution
Unplug the adaptor and plug
it again
Plug the adaptor into the 5V
2,5 A input port to activate
the device
Remove the battery of your
Notebook and use this
appliance to supply power for
it directly, or disconnect
Jump Starter from your
Notebook and connect them
when it is cool.
WWW.NIKOLAOUTOOLS.GR